Proposals

Subcontractor proposal software that starts from your numbers.

The proposal is the only part of the estimate the GC reads. In ScopeDive it is built from the estimate itself: the scopes, the alternates, the qualifications and exclusions you chose, on your letterhead, exported as a PDF. No retyping, so the proposal and the number can never disagree.

ScopeDive proposal: the company letterhead and logo, the project and customer details, and the first base-bid scopes with their descriptions

From estimate to proposal

Everything on the proposal already exists in the estimate.

In a spreadsheet shop, the proposal is a Word document someone builds at the end of bid day: scope descriptions copied from the estimate, totals typed by hand, the exclusions from the last job pasted in and edited, mostly. That is where the expensive mistakes hide: a scope priced but not listed, an exclusion that no longer applies, an alternate added to the base by accident.

ScopeDive turns the estimate into a client proposal directly. The base-bid scopes come with their descriptions. Alternates are listed beside the base bid, never inside it. Costs can be grouped the way the client wants to see them. Then export the PDF.

The proposal is also where a GC levels your bid against others. A clean base number, alternates kept separate, scopes described in the GC's words and exclusions tied to the scope they belong to make your bid easy to compare fairly, and hard to misread. That is worth more than any cover-letter wording.

Because the proposal comes from the estimate, a new revision means a proposal that matches it. And when a bid is above someone's limit, it goes through approval before it goes out.

What goes on it

  • Your company letterhead and logo
  • The project and the customer
  • Base-bid scopes with their descriptions
  • Alternates, add or deduct, listed separately
  • The qualifications, exclusions and notes you chose to show
  • Bid cost grouping the way the client asks for it

Proposals follow your units: each company picks metric or imperial in Settings, and takeoffs, estimates, the library and proposals all follow.

Proposals are included in every plan, Starter included. See pricing.

Qualifications and exclusions

Write the qualification on the scope it belongs to.

Qualifications and exclusions protect your number, but only when they are specific. "Excludes field touch-up" means something when it sits under the stair it applies to. In a boilerplate list at the bottom of page three, it reads as noise.

In ScopeDive, notes, qualifications and exclusions live on each scope. For each one you decide whether it shows on the proposal or stays internal, for the team only. The estimator writes the note while the reason is fresh, and the proposal carries it to the GC.

ScopeDive scope page: cost bucket totals at the top, then the scope setup and scope notes, with a qualification and an exclusion marked to show on the proposal and a note kept internal

Practical advice

Five habits of proposals that hold up.

Good software helps, but the habits matter more. What experienced estimators do on every proposal:

  1. Name the documents.List the drawings, specs and addenda the price is based on. When the set changes, this line is what makes a change order easy.
  2. Describe each scope in the GC's words.Use the spec section and drawing references, so the GC can match your scope to their bid form.
  3. Keep alternates out of the base.Number them and price them on their own. A GC comparing bids needs to see your base number cleanly.
  4. Make exclusions specific.Tie them to scopes. Remove the ones that do not apply to this job.
  5. Send the revision, not just the number.When a price changes, say which revision it is and what changed. See how to defend your number.

See it on your work

Price your next bid in ScopeDive.

Book a 20-minute tour and bring a bid you recently priced. We will show you how your library, your rates and your cost structure would look in ScopeDive.